Debug cfm, Syntax – Dell POWEREDGE M1000E User Manual
Page 423
Ethernet CFM Commands
423
Out-of-order Loopback Replies received: 0
Bad MSDU Loopback Replies received : 0
Loopback Replies transmitted : 5
Unexpected LTR's received : 0
------------------------------------------------------------------
Statistics for 'Domain: domain1, Level: 1, Vlan: 11, MEP Id: 2'
------------------------------------------------------------------
Out-of-sequence CCM's received : 0
CCM's transmitted : 1
In-order Loopback Replies received : 5
Out-of-order Loopback Replies received: 5
Bad MSDU Loopback Replies received : 0
Loopback Replies transmitted : 0
Unexpected LTR's received : 0
------------------------------------------------------------------
Statistics for 'Domain: domain1, Level: 1, Vlan: 11, MEP Id: 3'
------------------------------------------------------------------
Out-of-sequence CCM's received : 0
CCM's transmitted : 1
In-order Loopback Replies received : 0
Out-of-order Loopback Replies received: 0
Bad MSDU Loopback Replies received : 0
Loopback Replies transmitted : 5
Unexpected LTR's received : 0
debug cfm
Use the debug cfm command in Privileged EXEC mode to enable CFM
debugging. Use the no form of the command to disable debugging.
Syntax
debug cfm { event | {pdu { all | ccm | ltm | lbm | } {tx | rx} }}
2CSPC4.XModular-SWUM200.book Page 423 Thursday, March 10, 2011 11:18 AM