Dell POWEREDGE M1000E User Manual
Page 135
Command Groups
135
ipv6 ospf transmit-delay Sets the OSPF Transmit Delay for the specified
interface.
IC
ipv6 router ospf
Enters Router OSPFv3 Configuration mode.
GC
maximum-paths
Sets the number of paths that OSPF can report
for a given destination.
ROSV3
nsf
Enables OSPF graceful restart.
ROSV3
nsf helper
Allows OSPF to act as a helpful neighbor for a
restarting router.
ROSV3
nsf helper strict-lsa-
checking
Requires that an OSPF helpful neighbor exit
helper mode whenever a topology change occurs.
ROSV3
nsf restart-interval
Configures the length of the grace period on the
restarting router.
ROSV3
passive-interface
Sets the interface or tunnel as passive.
IC
passive-interface default Enables the global passive mode by default for all
interfaces.
ROSV3
redistribute
Configures the OSPFv3 protocol to allow
redistribution of routes from the specified source
protocol/routers.
ROSV3
router-id
Sets a 4-digit dotted-decimal number uniquely
identifying the Router OSPF ID.
ROSV3
show ipv6 ospf
Displays information relevant to the OSPF
router.
PE
show ipv6 ospf abr
Displays the internal OSPFv3 routes to reach
Area Border Routers (ABR).
PE
show ipv6 ospf area
Displays information about the area.
PE
show ipv6 ospf asbr
Displays the internal OSPFv3 routes to reach
Autonomous System Boundary Routes (ASBR).
PE
show ipv6 ospf border-
routers
Displays internal OSPFv3 routers to reach Area
Border Routers (ABR) and Autonomous System
Boundary Routers (ASBR).
UE or
PE
show ipv6 ospf database Displays information about the link state
database when OSPFv3 is enabled.
PE
Command
Description
Mode
a
2CSPC4.XModular-SWUM200.book Page 135 Thursday, March 10, 2011 11:18 AM