Dell POWEREDGE M1000E - Manual (Page 809)

ARP Commands 809
next hops in its route to the destination are through interfaces other than the
interface that received the ARP request. Use the no form of the command to
disable proxy ARP on a router interface.
Syntax
ip proxy-arp
no ip proxy-arp
Default Configuration
Enabled is the default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example enables proxy arp for VLAN 15.
(config)#interface vlan 15
console(config-if-vlan15)#ip proxy-arp
show arp
Use the show arp command in Privileged EXEC mode to display all entries in
the Address Resolution Protocol (ARP) cache. The displayed results are not
the total ARP entries. To view the total ARP entries, the operator should view
the show ARP results in conjunction with the show ARP switch results.
Syntax
show arp [brief]
• brief — Display ARP parameters.
2CSPC4.XModular-SWUM200.book Page 809 Thursday, March 10, 2011 11:18 AM