Dell POWEREDGE M1000E - Manual (Page 514)

514 iSCSI Optimization Commands
QoS treatment is accomplished by monitoring traffic to detect packets used
by iSCSI stations to establish iSCSI sessions and connections. Data from
these exchanges is used to create classification rules that assign the traffic
between the stations to a configured traffic class. Packets in the flow are
queued and scheduled for egress on the destination port based on these rules.
In addition, if configured, the packets can be updated with IEEE 802.1p or
IP-DSCP values. This is done by enabling remark. Remarking packets with
priority data provides special QoS treatment as the packets continue through
the network.
Commands in this Chapter
This chapter explains the following commands:
iscsi aging time
The iscsi aging time command sets the time out value for iSCSI sessions. To
reset the aging time to the default value, use the no form of this command.
Syntax
iscsi aging time time
no iscsi aging time
• time — The number of minutes a session must not be active prior to it's
removal. (Range: 1 43,200)
Default Configuration
The default aging time is 5 minutes.
Command Mode
Global Configuration mode.
iscsi aging time iscsi target port
iscsi cos show iscsi
iscsi enable show iscsi sessions
2CSPC4.XModular-SWUM200.book Page 514 Thursday, March 10, 2011 11:18 AM