Dell POWEREDGE M1000E - Manual (Page 1387)

Management ACL Commands 1383
Management access list names can consist of any printable character,
including blanks. Enclose the name in quotes to embed blanks in the name.
Examples
The following example shows how to configure two management interfaces,
gigabit Ethernet 1/0/1 and gigabit Ethernet 2/0/9.
console(config)#management access-list mlist
console(config-macal)# permit gigabitethernet 1/0/1 priority 1
console(config-macal)# permit gigabitethernet 2/0/9 priority 1
console(config-macal)# exit
console(config)#management access-class mlist
The following example shows how to configure all the interfaces to be
management interfaces except for two interfaces, gigabit Ethernet 1/0/1 and
gigabit Ethernet 2/0/9.
console(config)# management access-list mlist
console(config-macal)# deny gigabitethernet 1/0/1 priority 1
console(config-macal)# deny gigabitethernet 2/0/9 priority 2
console(config-macal)# permit priority 2
console(config-macal)# exit
console(config) # management access-class mlist
permit (management)
Use the permit command in Management Access-List configuration mode to
set conditions for the management access list.
Syntax
permit ip-source ip-address [mask mask | prefix-length ] [gigabitethernet
unit/slot/port | vlan vlan-id | port-channel port-channel-number |
tengigabitethernet unit/slot/port ] [ service service ] [ priority priority-value ]
permit {gigabitethernet unit/slot/port | vlan vlan-id | port-channel port-
channel-number | tengigabitethernet unit/slot/port } [service service ]
[priority priority-value ]
permit service service [priority priority-value ]
permit priority priority-value
2CSPC4.XModular-SWUM200.book Page 1383 Thursday, March 10, 2011 11:18 AM