Dell POWEREDGE M1000E - Manual (Page 1111)

OSPF Commands 1111
passive-interface default
The passive-interface default command enables the global passive mode by
default for all interfaces. It overrides any interface level passive mode. Use the
“no” form of this command to disable the global passive mode by default for
all interfaces. Any interface previously configured to be passive reverts to non-
passive mode.
Syntax
passive-interface default
no passive-interface default
Default Configuration
Global passive mode is disabled by default.
Command Mode
Router OSPF Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-router)#passive-interface
passive-interface
Use the passive-interface command to set the interface as passive. It
overrides the global passive mode that is currently effective on the interface.
Use the “no” form of this command to set the interface as non-passive.
Syntax
passive-interface vlan vlan-id
no passive-interface vlan vlan-id
• vlan-id — The vlan number
2CSPC4.XModular-SWUM200.book Page 1111 Thursday, March 10, 2011 11:18 AM