Dell POWEREDGE M1000E - Manual (Page 1146)

1146 OSPFv3 Commands
Default Configuration
If no metric is defined, 10 is the default configuration.
The default role is candidate.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures not-so-stubby-area 10 as an NSSA.
console(config)#ipv6 router ospf
console(config-router)#area 10 nssa
The following example configures the metric value and type for the default
route advertised into the NSSA and configures the NSSA so that summary
LSAs are not advertised into the NSSA.
console(config-router)#area 20 nssa default-info-
originate metric 250 metric-type 2 no-summary
area nssa default-info-originate
Use the area nssa default-info-originate command in Router OSPFv3
Configuration mode to configure the metric value and type for the default
route advertised into the NSSA. The optional metric parameter specifies the
metric of the default route. The metric type can be comparable (nssa-external
1) or noncomparable (nssa-external 2). Use the no form of the command to
return the metric value and type to the default value
Syntax
area areaid nssa default-info-originate [ metric [comparable | non-
comparable]]
no area
areaid nssa default-info-originate
• areaid — Valid OSPFv3 area identifier.
2CSPC4.XModular-SWUM200.book Page 1146 Thursday, March 10, 2011 11:18 AM