Show classofservice trust, Syntax, Default configuration – Dell POWEREDGE M1000E User Manual
Page 640: Command mode, User guidelines, Example, Show classofservice, Trust
640
QoS Commands
58
3
59
3
60
3
61
3
62
3
63
3
console#
show classofservice trust
Use the show classofservice trust command in Privileged EXEC mode to
display the current trust mode setting for a specific interface.
Syntax
show classofservice trust [{gigabitethernet
unit/slot/port
| port-channel
port-
channel-number
| tengigabitethernet
unit/slot/port
}]
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
If the interface is specified, the port trust mode of the interface is displayed.
If omitted, the port trust mode for global configuration is shown.
Example
The following example displays the current trust mode settings for the
specified port.
console#show classofservice trust 1/0/2
Class of Service Trust Mode: Dot1P
2CSPC4.XModular-SWUM200.book Page 640 Thursday, March 10, 2011 11:18 AM