Dell POWEREDGE M1000E - Manual (Page 964)

964 IPv6 Routing Commands
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables IPv6 routing, which has not been configured
with an explicit IPv6 address.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 enable
ipv6 hop-limit
Use the ipv6 hop-limit command to configure the hop limit used in IPv6
PDUs originated by the router. Use the no form of the command to return
the hop limit to the default setting.
Syntax
ipv6 hop-limit count
no ipv6 hop-limit
Parameter Description
Default Configuration
The default count is 64 hops.
Parameter Description
count The number of hops before the PDU expires (Range 0-255).
2CSPC4.XModular-SWUM200.book Page 964 Thursday, March 10, 2011 11:18 AM