Dell POWEREDGE M1000E - Manual (Page 1277)

Captive Portal Commands 1275
Example
console(config-CP)#enable
http port
Use the http port command to configure an additional HTTP port for captive
portal to monitor. Use the “no” form of this command to remove the
additional HTTP port from monitoring.
Syntax
http port port-num
no http port
• port-num —The port number to monitor (Range: 1–65535).
Default Configuration
Captive portal only monitors port 80 by default.
Command Mode
Captive Portal Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP)#http port 81
console(config-CP)#no http port
https port
Use the https port command to configure an additional HTTPS port for
captive portal to monitor. Use the “no” form of this command to remove the
additional HTTPS port from monitoring.
Syntax
https port port-num
2CSPC4.XModular-SWUM200.book Page 1275 Thursday, March 10, 2011 11:18 AM