Dell POWEREDGE M1000E - Manual (Page 1404)

1400 Password Management Commands
passwords strength max-limit consecutive-
characters
Use this command to enforce a maximum number of consecutive characters
that a password can contain. If a user enters a password that has more
consecutive characters than the configured limit, the system rejects the
password. The valid range of consecutive characters is 0–15. The default is 0.
A maximum of 0 means there is no restriction on consecutive characters.
Examples of consecutive characters are ABCDEF or 123456 or !”#$%&’().
Use the no form of this command to reset the maximum consecutive
characters accepted to the default value.
Syntax
passwords strength max-limit consecutive–characters 0–15
no passwords strength max-limit consecutive-characters
Parameter Description
This command does not require parameter descriptions.
Default Behavior
The default value is 0.
Command Mode
Global Configuration
User Guidelines
This command has no user guidelines.
Example
console(config)#passwords strength max-limit consecutive-characters 3
2CSPC4.XModular-SWUM200.book Page 1400 Thursday, March 10, 2011 11:18 AM