Dell POWEREDGE M1000E - Manual (Page 1158)

1158 OSPFv3 Commands
• neighbor — Router ID of neighbor.
• seconds — Retransmit interval. (Range: 0-3600)
Default Configuration
5 is the default value for seconds .
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the retransmit interval of 20 seconds for
the OSPF virtual interface on the virtual interface identified by area 1 and its
neighbor.
(config)#ipv6 router ospf
(config-rtr)#area 1 virtual-link 2 retransmit-
interval 20
area virtual-link transmit-delay
Use the area virtual-link transmit-delay command in Router OSPFv3
Configuration mode to configure the transmit delay for the OSPF virtual
interface on the virtual interface identified by areaid and neighbor .
Syntax
area areaid virtual-link neighbor transmit-delay seconds
no area areaid virtual-link neighbor transmit-delay
• areaid — Valid OSPFv3 area identifier.
• neighbor — Router ID of neighbor.
• seconds — Transmit delay interval. (Range: 0-3600)
2CSPC4.XModular-SWUM200.book Page 1158 Thursday, March 10, 2011 11:18 AM