Dell POWEREDGE M1000E - Manual (Page 1477)

SNMP Commands 1473
77
SNMP Commands
The SNMP component provides a machine-to-machine interface for the
PowerConnect product family. This includes the ability to configure the
network device, view settings and statistics, and upload or download code or
configuration images. The agent includes a get-bulk command to reduce
network management traffic when retrieving a sequence of Management
Information Base (MIB) variables and an elaborate set of error codes for
improved reporting to the network control station. The extensible and
advanced design of the PowerConnect SNMP makes adding remote
manageability to networked devices undemanding. The agent allows a
network control station to retrieve reports from the networked device. These
reports are based upon the defined objects in the MIB. The agent queries,
reports, and sets MIB variables based upon directions from the network
control station or upon preset conditions.
Commands in this Chapter
This chapter explains the following commands:
show snmp
Use the show snmp command in Privileged EXEC mode to display the SNMP
communications status.
show snmp snmp-server community-
group
snmp-server user
show snmp engineID snmp-server contact snmp-server view
show snmp filters snmp-server enable traps snmp-server v3-host
show snmp group snmp-server engineID local
show snmp user snmp-server filter
show snmp views snmp-server group
show trapflags snmp-server host
snmp-server community snmp-server location
2CSPC4.XModular-SWUM200.book Page 1473 Thursday, March 10, 2011 11:18 AM