Dell POWEREDGE M1000E - Manual (Page 1103)

OSPF Commands 1103
broadcast Set the OSPF network type to Broadcast
point-to-point Set the OSPF network type to Point-to-Point
ip ospf priority
Use the ip ospf priority command in Interface Configuration mode to set the
OSPF priority for the specified router interface. Use the no form of the
command to return the priority to the default value.
Syntax
ip ospf priority number-value
no ip ospf priority
• number-value — Specifies the OSPF priority for the specified router
interface. (Range: 0–255)
Default Configuration
1 is the default integer value.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
A value of 1 is the highest router priority. A value of 0 indicates that the
interface is not eligible to become the designated router on this network.
Example
The following example sets the OSPF priority for the VLAN 15 router at 100.
console(config-if-vlan15)#ip ospf priority 100
ip ospf retransmit-interval
Use the ip ospf retransmit-interval command in Interface Configuration
mode to set the OSPF retransmit Interval for the specified interface. Use the
no form of the command to return the interval to the default value.
2CSPC4.XModular-SWUM200.book Page 1103 Thursday, March 10, 2011 11:18 AM