Dell POWEREDGE M1000E - Manual (Page 1019)

Multicast Commands 1019
ip mcast boundary
Use the ip mcast boundary command in Interface Configuration mode to
add an administrative scope multicast boundary specified by groupipaddr and
mask for which this multicast administrative boundary is applicable.
groupipaddr is a group IP address and mask is a group IP mask.
Syntax
ip mcast boundary groupipaddr mask
no ip mcast boundary groupipaddr mask
• groupipaddr — IP address of multicast group. Valid range is 239.0.0.0 to
239.255.255.255.
• mask — IP mask of multicast group.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example adds an administrative scope multicast boundary.
console(config)#interface vlan 15
console(config-if-vlan15)#ip mcast boundary 239.5.5.5
255.255.255.255
ip mroute
Use the ip mroute command to create a static multicast route for a source
range. Use the no form of this command to delete a static multicast route.
2CSPC4.XModular-SWUM200.book Page 1019 Thursday, March 10, 2011 11:18 AM