Ip address (out-of-band), Syntax, Parameter description – Dell POWEREDGE M1000E User Manual
Page 462: Default configuration, Command mode
462
IP Addressing Commands
console(config-if)#
ip address (Out-of-Band)
Use the ip address command in Interface Configuration mode to set an IP
address for the service port. Use the no form of this command to return the ip
address configuration to its default value.
Syntax
ip address {
ip-address
{
mask
|
prefix-length
} | dhcp}
no ip address
Parameter Description
Default Configuration
The out-of-band interface (service port) obtains an IP address via DHCP by
default.
Command Mode
Interface (Out-of-Band) Configuration mode
Parameter
Description
ip-address
Specifies a valid IP address.
mask
Specifies a valid subnet (network) mask IP address.
prefix-length
The number of bits that comprise the IP address prefix. The
prefix length must be preceded by a forward slash (/). (Range: 1-
30 bits)
dhcp
Obtain the service port address via DHCPv4.
2CSPC4.XModular-SWUM200.book Page 462 Thursday, March 10, 2011 11:18 AM