Dell POWEREDGE M1000E - Manual (Page 941)

IPv6 PIM Commands 941
Default Configuration
PIM is disabled by default.
Command Mode
Global Configuration mode
User Guidelines
Only one of sparse or dense mode can be configured on a router.
Example
console(config)#ipv6 pim dense
ipv6 pim bsr-border
Use the ipv6 pim bsr-border command to administratively disable bootstrap
router (BSR) messages from being sent or received through an interface. Use
the no form of this command to return the configuration to the default.
Syntax
ipv6 pim bsr-border
no ipv6 pim bsr-border
Default Configuration
BSR messages are enabled on the interface by default.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
This command only has an effect if sparse mode is enabled. Lower values are
preferred.
Example
console(if-vlan-10)#ipv6 pim bsr-border
2CSPC4.XModular-SWUM200.book Page 941 Thursday, March 10, 2011 11:18 AM