Dell POWEREDGE M1000E - Manual (Page 1095)

OSPF Commands 1095
no enable
Default Configuration
Enabled is the default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables OSPF router mode.
console(config-router)#enable
exit-overflow-interval
Use the exit-overflow-interval command in Router OSPF Configuration
mode to configure the exit overflow interval for OSPF. When a router leaves
the overflow state it can originate non-default AS-external-LSAs. When set to
0, the router will not leave Overflow State until restarted. Use the no form of
the command to return the interval to the default value.
Syntax
exit-overflow-interval seconds
no exit-overflow-interval
• seconds — Number of seconds after entering overflow state that a router
will wait before attempting to leave the overflow state. (Range:
0–2147483647)
Default Configuration
0 seconds is the default configuration.
Command Mode
Router OSPF Configuration mode.
2CSPC4.XModular-SWUM200.book Page 1095 Thursday, March 10, 2011 11:18 AM