Dell POWEREDGE M1000E - Manual (Page 1555)

System Management Commands 1551
Reloading management switch 1.
set description
Use the set description command in Stack Global Configuration mode to
associate a text description with a switch in the stack.
Syntax
set description unit description
• unit — The switch identifier. (Range: 1–12)
• description — The text description. (Range: 1–80 alphanumeric
characters)
Default Configuration
This command has no default configuration.
Command Mode
Stack Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays
console(config)#stack
console(config-stack)#set description 1 “unit 1"
slot
NOTE: The slot command is only available to be used on PCM6348 when it is a
master switch in a mixed stack of PCM6348/PC7000 switches to configure the slot on a
slave PC7000 switch.
Use the slot command to configure a slot in the system. The unit/slot is the
slot identifier of the slot located in the specified unit. The cardindex is the
index to the database of the supported card types (see the command show
2CSPC4.XModular-SWUM200.book Page 1551 Thursday, March 10, 2011 11:18 AM