Dell POWEREDGE M1000E - Manual (Page 968)

968 IPv6 Routing Commands
Syntax
ipv6 mld-proxy reset-status
Command Mode
Interface Configuration (VLAN) mode.
Default Configuration
There is no default configuration for this command.
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 mld-proxy reset-status
ipv6 mld-proxy unsolicit-rprt-interval
Use the ipv6 mld-proxy unsolicit-rprt-interval command to set the
unsolicited report interval for the MLD Proxy router. This command is only
valid when MLD Proxy is enabled on the interface. Use the “no” form of this
command to reset the MLD Proxy router's unsolicited report interval to the
default value.
Syntax
ipv6 mld-proxy unsolicited-report-interval interval
no ipv6 mld-proxy unsolicited-report-interval
• interval —The interval between unsolicited reports (Range: 1–260
seconds).
Default Configuration
The unsolicited report interval is 1 second by default.
Command Mode
Interface Configuration (VLAN) mode.
2CSPC4.XModular-SWUM200.book Page 968 Thursday, March 10, 2011 11:18 AM