Dell POWEREDGE M1000E - Manual (Page 1570)

1566 System Management Commands
Example
The following example displays sample output of the show slot command.
console#show slot
Admin Power Configured Card
Slot Status State State Model ID Pluggable
----- ------ ------- ------- ------------------------- ------------
1/0 Full Enable Enable PCM8024-k No
1/1 Full Enable Enable DELL Ten-Gig SFP+ Card Yes
show supported cardtype
Use the show supported cardtype command in User EXEC mode to display
information about all card types supported in the system. If a card index is
entered, then the command displays information about specific card types
supported in the system. Card index values are specific to each family of
products. Use the generic form (without specifying an index) to display all the
card types for a product family.
Syntax
show supported cardtype [ cardindex ]
• cardindex — Displays the index into the database of the supported card
types. This index is used when preconfiguring a slot.
The following table explains the output parameters.
If you supply a value for cardindex , the following additional information
appears as shown in the table below.
Parameter Description
Card Index (CID) The index into the database of the
supported card types. This index is used
when preconfiguring a slot.
Card Model Identifier The model identifier for the supported
card type.
2CSPC4.XModular-SWUM200.book Page 1566 Thursday, March 10, 2011 11:18 AM