Dell POWEREDGE M1000E - Manual (Page 1150)

1150 OSPFv3 Commands
console(config-rtr)#area 1 nssa translator-role
always
area nssa translator-stab-intv
Use the area nssa translator-stab-intv command in Router OSPFv3
Configuration mode to configure the translator stability interval of the NSSA.
The stability interval is the period of time that an elected translator continues
to perform its duties after it determines that its translator status has been
deposed by another router.
Syntax
area areaid nssa translator-stab-intv seconds
no area areaid nssa translator-stab-intv
• areaid — Valid OSPF area identifier.
• seconds — Translator stability interval of the NSSA. (Range: 0-3600
seconds)
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures a translator stability interval of 100 seconds
for the area 1 NSSA.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 nssa translator-stab-intv
100
2CSPC4.XModular-SWUM200.book Page 1150 Thursday, March 10, 2011 11:18 AM