Dell POWEREDGE M1000E - Manual (Page 1497)

SNMP Commands 1493
• writeview — A string that is the name of the view that enables the user to
enter data and configure the contents of the agent. If unspecified, nothing
is defined for the write view. (Range: 1-30 characters.)
Default Configuration
No group entry exists. There will be some default groups for
Read/Write/Super users. These groups cannot be deleted or modified by the
user. This command is used only to configure the user-defined groups.
Command Mode
Global Configuration Mode
User Guidelines
View-name should be an existing view created using the snmp-server view
command. If there are multiple records with the same view-name, then the
argument specified in this command points to first view-name in the table.
Example
The following example attaches a group called user-group to SNMPv3 and
assigns to the group the privacy security level and read access rights to a view
called user-view.
console(config)# snmp-server group user-group v3 priv
read user-view
snmp-server host
Use the snmp-server host command in Global Configuration mode to specify
the recipient of Simple Network Management Protocol notifications. To
remove the specified host, use the no form of this command. This command
enters the user into SNMP-host configuration mode.
Syntax
snmp-server host host-addr [informs [timeout seconds ] [retries retries ] |
traps version {1 | 2 }]] community-string [udp-port port ] [filter filtername ]
no snmp-server host host-addr { traps | informs }
2CSPC4.XModular-SWUM200.book Page 1493 Thursday, March 10, 2011 11:18 AM