Dell POWEREDGE M1000E - Manual (Page 901)

IP Helper/DHCP Relay Commands 901
Example
The following example defines a minimum wait time of 10 seconds.
console(config)#bootpdhcprelay minwaittime 10
clear ip helper statistics
Use the clear ip helper statistics command to reset to 0 the statistics
displayed in show ip helper statistics.
Syntax
clear ip helper statistics
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
console#clear ip helper statistics
ip dhcp relay information check
Use the ip dhcp relay information check command to enable DHCP Relay to
check that the relay agent information option in forwarded BOOTREPLY
messages is valid. If an invalid message is received, the relay agent drops it.
This information check will take effect, though enabled, only when the relay
agent interface is enabled to insert the sub-options.
Syntax
ip dhcp relay information check
no ip dhcp relay information check
2CSPC4.XModular-SWUM200.book Page 901 Thursday, March 10, 2011 11:18 AM