Dell POWEREDGE M1000E - Manual (Page 346)

346 Dynamic ARP Inspection Commands
Default Configuration
There is no additional validation enabled by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command
Example
console(config)#ip arp inspection validate src-mac
dst-mac ip
console(config)#ip arp inspection validate src-mac ip
console(config)#ip arp inspection validate dst-mac ip
console(config)#ip arp inspection validate ip
ip arp inspection vlan
Use the ip arp inspection vlan command to enable Dynamic ARP Inspection
on a single VLAN or a range of VLANs. Use the no form of this command to
disable Dynamic ARP Inspection on a single VLAN or a range of VLANs.
Syntax
ip arp inspection vlan vlan-range [ logging ]
no ip arp inspection vlan vlan-range [ logging ]
• vlan-range — A valid range of VLAN IDs.
• logging — Use this parameter to enable logging of invalid packets.
Default Configuration
Dynamic ARP Inspection is disabled by default.
Command Mode
Global Configuration mode
2CSPC4.XModular-SWUM200.book Page 346 Thursday, March 10, 2011 11:18 AM