Dell POWEREDGE M1000E - Manual (Page 846)

846 DHCPv6 Commands
FILE LOCATION: C:\My Documents\ActiveProjects\2CSPC7000-SWUM400 Dell Zeiss CLI
Guide\working\DHCPv6.fm
D E L L C O NF I D E N TI A L – P R EL I M I N A RY 3/ 1 0 / 1 1 - F O R P R O O F O N LY
• pool-name — DHCPv6 pool name. (Range: 1-31 characters)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example enters IPv6 DHCP Pool Configuration mode.
console(config)#ipv6 dhcp pool addrpool
console(config-dhcp6s-pool)#
ipv6 dhcp relay
Use the ipv6 dhcp relay command in Interface Configuration mode to
configure an interface for DHCPv6 relay functionality.
Syntax
ipv6 dhcp relay {destination relay-address [interface vlan vlan-id ] | interface
vlan vlan-id }[remote-id {duid-ifid | user-defined-string }]
• destination — Keyword that sets the relay server IPv6 address.
•
relay-address — An IPv6 address of a DHCPv6 relay server.
• interface — Sets the relay server interface.
• vlan-id — A valid VLAN ID.
• [remote-id {duid-ifid | user-defined-string }] — The Relay Agent
Information Option “remote ID” sub-option to be added to relayed
messages. This can either be the special keyword duid-ifid, which causes
the “remote ID” to be derived from the DHCPv6 server DUID and the
relay interface number, or it can be specified as a user-defined string.
2CSPC4.XModular-SWUM200.book Page 846 Thursday, March 10, 2011 11:18 AM