Default configuration, Command mode, User guidelines – Dell POWEREDGE M1000E User Manual
Page 1217: Example, Enable, Syntax
Routing Information Protocol Commands
1217
Default Configuration
This command has no default configuration.
Command Mode
Router RIP Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example elects access list ACL40 to filter routes received from
the source protocol.
console(config-router)#distribute-list ACL40 out
static
enable
Use the enable command in Router RIP Configuration mode to reset the
default administrative mode of RIP in the router (active). Use the no form of
the command to disable the administrative mode for RIP.
Syntax
enable
no enable
Default Configuration
Enabled is the default configuration.
Command Mode
Router RIP Configuration mode.
User Guidelines
This command has no user guidelines.
2CSPC4.XModular-SWUM200.book Page 1217 Thursday, March 10, 2011 11:18 AM