Dell POWEREDGE M1000E - Manual (Page 442)

442 IGMP Snooping Commands
Syntax
ip igmp snooping mrouter-time-out time-out
no ip igmp snooping mrouter-time-out
• time-out — mrouter timeout in seconds for IGMP. (Range: 1–3600)
Default Configuration
The default value is 300 seconds.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the mrouter timeout to 200 seconds.
console(config-if-1/0/1)#ip igmp snooping mrouter-
time-out 200
show ip igmp snooping
Use the show ip igmp snooping command in Privileged EXEC mode to
display the IGMP snooping configuration.
Syntax
show ip igmp snooping [vlan vlan-id ]
Parameter Description
Parameter Description
vlan-id Specifies a VLAN ID value (available only in Privileged EXEC
mode).
2CSPC4.XModular-SWUM200.book Page 442 Thursday, March 10, 2011 11:18 AM