Dell POWEREDGE M1000E - Manual (Page 343)

Dynamic ARP Inspection Commands 343
Example
console#clear ip arp inspection statistics
ip arp inspection filter
Use the ip arp inspection filter command to configure the ARP ACL to be
used for a single VLAN or a range of VLANs to filter invalid ARP packets. If
the static keyword is given, packets that do not match a permit statement are
dropped without consulting the DHCP snooping bindings. Use the “no” form
of this command to unconfigure the ARP ACL.
Syntax
ip arp inspection filter acl-name vlan vlan-range [static]
no ip arp inspection filter acl-name vlan vlan-range [static]
• acl-name —The name of a valid ARP ACL. (Range: 1–31 characters)
• vlan-range —A valid VLAN range.
Default Configuration
No ARP ACL is configured.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ip arp inspection filter tier1 vlan 2-10 static
console(config)#ip arp inspection filter tier1 vlan 20-30
ip arp inspection limit
Use the ip arp inspection limit command to configure the rate limit and
burst interval values for an interface.
2CSPC4.XModular-SWUM200.book Page 343 Thursday, March 10, 2011 11:18 AM