Dell POWEREDGE M1000E - Manual (Page 375)

Ethernet Configuration Commands 375
Example
The following example configures the duplex operation of gigabit Ethernet
port 1/0/5 to force full duplex operation.
console(config)# interface gigabitethernet 1/0/5
console(config-if)# duplex full
flowcontrol
Use the flowcontrol command in Global Configuration mode to configure
the flow control. To disable flow control, use the no form of this command.
Syntax
flowcontrol
no flowcontrol
Default Configuration
Flow Control is enabled by default.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
In the following example, flow control is enabled.
console(config)# flowcontrol
interface
Use this command to configure parameters for the gigabit Ethernet and ten-
gigabit Ethernet ports, and for port-channels. While in Global Configuration
mode, enter the interface command (with a specific interface). To exit to
Global Configuration mode, enter exit. To return to Privileged EXEC mode,
press Ctrl-Z or enter end.
2CSPC4.XModular-SWUM200.book Page 375 Thursday, March 10, 2011 11:18 AM