Dell POWEREDGE M1000E - Manual (Page 725)

VLAN Commands 725
Example
The following example configures a VLAN name of office2 for VLAN 2.
console(config)#interface vlan 2
console(config-vlan)#name "RDU-NOC Management VLAN"
protocol group
Use the protocol group command in VLAN Database mode to attach a
VLAN ID to the protocol-based group identified by groupid . A group may
only be associated with one VLAN at a time. However, the VLAN association
can be changed. The referenced VLAN should be created prior to the creation
of the protocol-based group except when GVRP is expected to create the
VLAN.
To detach the VLAN from this protocol-based group identified by this
groupid , use the no form of this command.
Syntax
protocol group groupid vlanid
no protocol group groupid vlanid
• groupid — The protocol-based VLAN group ID, which is automatically
generated when you create a protocol-based VLAN group with the vlan
protocol group command. To see the group ID associated with the name
of a protocol group, use the show port protocol all command.
• vlanid — A valid VLAN ID.
Default Configuration
This command has no default configuration.
Command Mode
VLAN Database mode
User Guidelines
This command has no user guidelines.
2CSPC4.XModular-SWUM200.book Page 725 Thursday, March 10, 2011 11:18 AM