Dell POWEREDGE M1000E - Manual (Page 1389)

Management ACL Commands 1385
console(config)# management access-class mlist
The following example shows how to configure all the interfaces to be
management interfaces except for two interfaces, gigabit Ethernet 1/0/1 and
2/0/9.
console(config)# management access-list mlist
console(config-macal)# deny gigabitethernet 1/0/1 priority 1
console(config-macal)# deny gigabitethernet 2/0/9 priority 2
console(config-macal)# permit priority 2
console(config-macal)# exit
console(config)# management access-class mlist
show management access-class
Use the show management access-class command in Privileged EXEC mode
to display information about the active management access list.
Syntax
show management access-class
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the management access-list information.
console# show management access-class
Management access-class is enabled, using access list mlist
2CSPC4.XModular-SWUM200.book Page 1385 Thursday, March 10, 2011 11:18 AM