Dell POWEREDGE M1000E - Manual (Page 1552)

1548 System Management Commands
User Guidelines
Nonstop forwarding allows the forwarding plane of stack units to continue to
forward packets while the control and management planes restart as a result
of a power failure, hardware failure, or software fault on the stack
management unit.
Example
console(config)#nsf
ping
Use the ping command in User EXEC mode to check the accessibility of the
desired node on the network.
Syntax
ping [ ip | ipv6 ] ipaddress | hostname [ repeat count ] [ timeout interval ] [
size size ]
• ipaddress — IP address to ping (contact).
• hostname — Hostname to ping (contact). (Range: 1–158 characters). The
command allows spaces in the host name when specified in double quotes,
even though host names may only consist of letters, numbers and the
hyphen character.
• count — Number of packets to send (Range: 1–15 packets).
• interval — The time between Echo Requests, in seconds (Range: 1–60
seconds).
• size — Number of data bytes in a packet (Range: 0–65507 bytes).
Default Configuration
The default count is 4.
The default interval is 3 seconds.
The default size is 0 data bytes.
Command Mode
User EXEC mode
2CSPC4.XModular-SWUM200.book Page 1548 Thursday, March 10, 2011 11:18 AM