Dell POWEREDGE M1000E - Manual (Page 386)

386 Ethernet Configuration Commands
console>show interfaces description
Port Description
---- -----------------------------------------------------
1/0/1 Port that should be used for management only
2/0/1
2/0/2
Ch Description
---- -----------
1 Output
show interfaces status
Use the show interfaces status command in User EXEC mode to display the
status for all configured interfaces.
Syntax
show interfaces status [gigabitethernet unit/slot/port | port-channel port-
channel-number | tengigabitethernet unit/slot/port ]
The displayed port status information includes the following:
Field Description
Port The port or port channel number. Oob means Out-of-Band
Management Interface.
Type The port designated IEEE shorthand identifier. For example,
1000Base-T refers to 1000 Mbps baseband signaling including both
Tx and Rx transmissions.
Duplex Displays the port Duplex status.
Speed Refers to the port speed.
Neg Describes the Auto-negotiation status.
Link State Displays the Link Aggregation status, either Up or Down.
2CSPC4.XModular-SWUM200.book Page 386 Thursday, March 10, 2011 11:18 AM