Dell POWEREDGE M1000E - Manual (Page 1023)

Multicast Commands 1023
console(config)#interface vlan 10
console(if-vlan-10)#ip pim
ip pim bsr-border
The ip pim bsr-border command is used in Interface (VLAN) Configuration
mode to administratively disable bootstrap router (BSR) messages on the
interface. Use the no form of this command to return the configuration to the
default.
Syntax
ip pim bsr-border
no ip pim bsr-border
Default Configuration
BSR messages are enabled on the interface by default.
Command Mode
Interface (VLAN) Configuration mode
User Guidelines
This command only has an effect if sparse mode is enabled. Lower values are
preferred.
Example
console(if-vlan-10)#ip pim bsr-border
ip pim bsr-candidate
The ip pim bsr-candidate command is used to configure the router to
advertise itself as a bootstrap router (BSR). Use the no form of this command
to return to the default configuration. This command replaces the ip pimsm
bsr-candidate, ip pimsm cbsrhaskmasklength and ip pimsm cbsrpreference
commands.
2CSPC4.XModular-SWUM200.book Page 1023 Thursday, March 10, 2011 11:18 AM