Dell POWEREDGE M1000E - Manual (Page 1230)

1230 Tunnel Interface Commands
interface tunnel
Use the interface tunnel command in Global Configuration mode to enter
the interface configuration mode for a tunnel.
Syntax
interface tunnel tunnel-id
no interface tunnel tunnel-id
• tunnel-id — Tunnel identifier. (Range: 0–7)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables the interface configuration mode for tunnel 1.
console(config)#interface tunnel 1
console(config-if-tunnel1)#
show interfaces tunnel
Use the show interfaces tunnel command in Privileged EXEC mode to
display the parameters related to tunnel such as tunnel mode, tunnel source
address and tunnel destination address.
Syntax
show interfaces tunnel [ tunnel-id ]
• tunnel-id — Tunnel identifier. (Range: 0–7)
2CSPC4.XModular-SWUM200.book Page 1230 Thursday, March 10, 2011 11:18 AM