Dell POWEREDGE M1000E - Manual (Page 726)

726 VLAN Commands
Example
The following example displays how to attach the VLAN ID "100" to the
protocol-based VLAN group "3."
console#vlan database
console(config-vlan)#protocol group 3 100
protocol vlan group
Use the protocol vlan group command in Interface Configuration mode to
add the physical unit/slot/port interface to the protocol-based group
identified by groupid . A group may have more than one interface associated
with it. Each interface and protocol combination can be associated with one
group only. If adding an interface to a group causes any conflicts with
protocols currently associated with the group, this command fails and the
interface(s) are not added to the group. Ensure that the referenced VLAN is
created prior to the creation of the protocol-based group except when GVRP
is expected to create the VLAN.
To remove the interface from this protocol-based VLAN group that is
identified by this groupid , use the no form of this command.
If you select all, all ports are removed from this protocol group.
Syntax
protocol vlan group groupid
no protocol vlan group groupid
• groupid — The protocol-based VLAN group ID, which is automatically
generated when you create a protocol-based VLAN group with the vlan
protocol group command. To see the group ID associated with the name
of a protocol group, use the show port protocol all command.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Ethernet) mode
2CSPC4.XModular-SWUM200.book Page 726 Thursday, March 10, 2011 11:18 AM