Dell POWEREDGE M1000E - Manual (Page 1085)

OSPF Commands 1085
• neighbor-id — Identifies the Router ID of the neighbor.
• seconds — The number of seconds to wait between retransmitting LSAs if
no acknowledgement is received. (Range: 0–3600)
Default Configuration
The default configuration is 5 seconds.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures a 500-second retransmit wait interval.
console(config-router)#area 10 virtual-link
192.168.2.2 retransmit-interval 500
area virtual-link transmit-delay
Use the area virtual-link transmit-delay command in Router OSPF
Configuration mode to configure the transmit delay for the OSPF virtual
interface identified by the area ID and neighbor ID. Use the no form of the
command to return the transmit delay to the default value.
Syntax
area area-id virtual-link neighbor-id transmit-delay seconds
no area area-id virtual-link neighbor-id transmit-delay
• area-id — Identifies the OSPF area to configure. (Range: IP address or
decimal from 0–4294967295)
• neighbor-id — Identifies the Router ID of the neighbor.
• seconds — Number of seconds to increment the age of the LSA before
sending, based on the estimated time it takes to transmit from the
interface. (Range: 0–3600)
2CSPC4.XModular-SWUM200.book Page 1085 Thursday, March 10, 2011 11:18 AM