Dell POWEREDGE M1000E - Manual (Page 529)

Link Dependency Commands 529
Command Mode
Link Dependency mode
User Guidelines
No specific guidelines
Example
console(config-depend-1)#add port-channel 10-12
depends-on
Use this command command to add the dependent Ethernet ports or port
channels list. Use the no depends-on command to remove the dependent
Ethernet ports or port-channels list.
Syntax
depends-on {gigabitethernet | port-channel | tengigabitethernet} intf-list
no depends-on {gigabitethernet | port-channel | tengigabitethernet} intf-
list
• intf-list — List of ports in unit/slot/port format or port-channel numbers.
Separate nonconsecutive items with a comma and no spaces. Use a hyphen
to designate the range of ports or port-channel numbers. (Range: Valid
Ethernet interface or port-channel list or range)
Default Configuration
This command has no default configuration.
Command Mode
Link Dependency mode
User Guidelines
Circular dependencies are not allowed, i.e. interfaces added to the group may
not also appear in the depends-on list.
2CSPC4.XModular-SWUM200.book Page 529 Thursday, March 10, 2011 11:18 AM