Dell POWEREDGE M1000E - Manual (Page 1021)

Multicast Commands 1021
no ip multicast
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example enables IP multicast on the router.
console#configure
console(config)#ip multicast
console(config)#no ip multicast
ip multicast ttl-threshold
Use the ip multicast ttl-threshold command in Interface Configuration
mode to apply a ttlvalue to a routing interface. ttlvalue is the TTL threshold
which is applied to the multicast Data packets forwarded through the
interface.
Syntax
ip multicast ttl-threshold ttlvalue
no ip multicast ttl-threshold
• ttlvalue — Specifies TTL threshold. (Range: 0-255)
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (VLAN) mode
2CSPC4.XModular-SWUM200.book Page 1021 Thursday, March 10, 2011 11:18 AM