Dell POWEREDGE M1000E - Manual (Page 518)

518 iSCSI Optimization Commands
Example
The following example iSCSI is globally enabled.
console(config)#iscsi enable
iscsi target port
Use the iscsi target port command in Global Configuration mode to
configure iSCSI port(s), target addresses and names. To delete iSCSI port(s)
or target ports, use the no form of this command.
Syntax
iscsi target port tcp-port-1 [ tcp-port-2.… tcp-port-18 [address ip-address ]
[name targetname ]
no iscsi target port tcp-port-1 [ tcp-port-2.… tcp-port-8 ] [address ip-address ]
Parameter Description
Parameter Description
tcp-port TCP port number or list of TCP port numbers on which iSCSI
target(s) listen to requests. Up to 16 TCP ports can be defined
in the system in one command or by using multiple commands.
ip-address IP address of the iSCSI target. When the no form is used, and
the tcp port to be deleted is one bound to a specific IP address,
the address field must be present.
targetname iSCSI name of the iSCSI target. The name can be statically
configured; however, it can be obtained from iSNS or from
sendTargets response. The initiator MUST present both its
iSCSI Initiator Name and the iSCSI Target Name to which it
wishes to connect in the first login request of a new session or
connection. The target name can consist of any printable
character except for an exclamation point, double quote, or a
question mark. The name can contain embedded blanks if
enclosed in double quotes.
2CSPC4.XModular-SWUM200.book Page 518 Thursday, March 10, 2011 11:18 AM