Dell POWEREDGE M1000E - Manual (Page 1056)

1056 IPv6 Multicast Commands
ipv6 pimsm rp-candidate
Use the ipv6 pimsm rp-candidate command to configure the router to
advertise itself as a PIM candidate rendezvous point (RP) to the bootstrap
router (BSR). Use the "no" form of this command to disable the router from
advertising itself as a PIM candidate rendezvous point (RP) to the bootstrap
router (BSR).
Syntax
ipv6 pimsm rp-candidate vlan vlan-id group-address/prefixlength
no ipv6 pimsm rp-candidate vlan vlan-id
• vlan-id—A valid VLAN ID value.
• group-address—The group address to display.
• prefixlength—This parameter specifies the prefix length of the IP address
for the media gateway. (Range: 1–32)
Default Configuration
The router does not advertise itself as a PIM candidate rendezvous point by
default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pimsm rp-candidate vlan 6
ff1e::/64
ipv6 pimsm spt-threshold
Use the ipv6 pimsm spt-threshold command to configure the Data
Threshold rate for the last-hop router to switch to the shortest path. Use the
"no" form of this command to set the data threshold to the default.
2CSPC4.XModular-SWUM200.book Page 1056 Thursday, March 10, 2011 11:18 AM