Dell POWEREDGE M1000E - Manual (Page 271)

Address Table Commands 271
• max-addr — The maximum number of addresses that can be learning on
the port. (Range: 0-600)
Default Configuration
The default value for this command is 100.
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet)
mode
User Guidelines
This command has no user guidelines.
Example
The following example shows using this command in Ethernet Interface
Configuration mode.
console(config-if-1/0/3)# port security max 80
show mac address-table multicast
Use the show mac address-table multicast command in Privileged EXEC
mode to display Multicast MAC address table information.
Syntax
show mac address-table multicast [vlan vlan-id ] [address { mac-multicast-
address | ip-multicast-address }] [format {ip | mac}]
• vlan_id — A valid VLAN ID value.
• mac-multicast-address — A valid MAC Multicast address.
• ip- multicast-address — A valid IP Multicast address.
• format — Multicast address format. Can be ip or mac.
Default Configuration
If format is unspecified, the default is mac.
2CSPC4.XModular-SWUM200.book Page 271 Thursday, March 10, 2011 11:18 AM