Dell POWEREDGE M1000E User Manual
Page 127
Command Groups
127
ip multicast
Sets the administrative mode of the IP
multicast forwarder in the router to active.
GC
ip multicast ttl-threshold
Applies a
ttlvalue to a routing interface.
IC
ip pim
Administratively configures PIM mode for IP
multicast routing on a VLAN interface.
IC
ip pim bsr-border
Administratively disables bootstrap router
(BSR) messages from being sent or received
through an interface.
IC
ip pim bsr-candidate
Configures the router to advertise itself as a
bootstrap router (BSR).
GC
ip pim dense
Administratively configures PIM dense mode
for IP multicast routing.
GC
ip pim dr-priority
Administratively configures the advertised
designated router (DR) priority value.
IC
ip pim hello-interval
Administratively configures the PIM Hello
messages on the specified interface.
IC
ip pim join-prune-interval Administratively configures the frequency of
join/prune messages on the specified interface.
IC
ip pim register-rate-limit
Sets a limit on the maximum number of PIM
register messages sent per second for each (S,G)
entry.
GC
ip pim rp-address
Defines the address of a PIM RP for a specific
multicast group range.
GC
ip pim rp-candidate
Configures the router to advertise itself to the
bootstrap router (BSR) as a PIM candidate
rendezvous point (RP) for a specific multicast
group range.
IC
ip pim sparse
Administratively configures PIM sparse mode
for IP multicast routing.
GC
ip pim ssm
Administratively configures PIM Source
Specific Multicast (SSM) range of addresses for
IP multicast routing.
GC
Command
Description
Mode
a
2CSPC4.XModular-SWUM200.book Page 127 Thursday, March 10, 2011 11:18 AM