Dell POWEREDGE M1000E - Manual (Page 924)

924 IP Routing Commands
Command Mode
Global Configuration mode
User Guidelines
Lower route distance values are preferred when determining the best route.
Example
The following example sets the default route metric to 80.
console(config)#ip route distance 80
ip routing
To globally enable IPv4 routing on the router, use the "ip routing" command
in Global Configuration mode. To disable IPv4 routing globally, use the no
form of this command.
NOTE: Enabling or disabling routing will cause in-band management connections to
be reset.
Syntax
ip routing
no ip routing
Default Configuration
The ip routing default configuration is disabled.
Command Mode
Global Configuration mode
User Guidelines
Use this command to globally enable IPv4 routing.
Example
console(config)#ip routing
2CSPC4.XModular-SWUM200.book Page 924 Thursday, March 10, 2011 11:18 AM