Dell POWEREDGE M1000E - Manual (Page 600)

600 QoS Commands
process is also used for cases where a trusted port mapping is unable to be
honored, such as when a nonIP packet arrives at a port configured to trust the
IP precedence or IP DSCP value.
PCM6220 Limitations
The PCM6220 switch does not support out-bound service policies or ACLs.
The following command syntax is not available:
• service-policy servicepolicyname out
• policy-map policymapname out
• mac access-group name out
• show diffserv service interface interface out
• show diffserv service port-channel port-channel out
• show policy-map interface interface out
The following command is not supported on VLAN interfaces on the
PCM6220:
ip access-group
name out
Commands in this Chapter
This chapter explains the following commands:
assign-queue mark cos match ip tos show classofservice
dot1p-mapping
class mark ip-dscp match protocol show classofservice ip-
dscp-mapping
class-map mark ip-
precedence
match source-
address mac
show classofservice
trust
class-map rename match class-map match srcip show diffserv
classofservice
dot1p-mapping
match cos match srcip6 show diffserv service
interface
classofservice ip-
dscp-mapping
match destination-
address mac
match srcl4port show diffserv service
interface port-channel
2CSPC4.XModular-SWUM200.book Page 600 Thursday, March 10, 2011 11:18 AM