Freescale Semiconductor MPC8260 - Manual (Page 593)

Serial Interface with Time-Slot Assigner
MPC8260 PowerQUICC II Family Reference Manual, Rev. 2
Freescale Semiconductor 15-17
15.5 Serial Interface Registers
The serial interface registers are described in the following sections. The MCC configuration registers,
which define the TDM mapping of the MCC channels, are described in
Section 28.6, “MCC Configuration
Registers (MCCFx).”
NOTE
The programming of SI registers and SIx RAM must be coherent with the
MCCF programming.
15.5.1 SI Global Mode Registers (SI x GMR)
The SI global mode registers (SIxGMR), shown in Figure 15-10., defines the activation state of the TDM
channels for each SI.
Table 15-4. describes SIxGMR.
15.5.2 SI Mode Registers (SI x MR)
There are eight SI mode registers (SIxMR), shown in Figure 15-11., one for each TDM channel (SIxAMR,
SIxBMR, SIxCMR, and SIxDMR). They are used to define SI operation modes and allow the user (with
SIx RAM) to support any or all of the ISDN channels independently when in IDL or GCI mode. Any extra
serial channel can then be used for other purposes.
0 1 2 3 4 5 6 7
Field STZD STZC STZB STZA END ENC ENB ENA
Reset 0000_0000
R/W R/W
Addr 0x0x11B28 (SI1GMR), 0x0x11B48 (SI2GMR)
Figure 15-10. SI Global Mode Registers (SI xGMR)
Table 15-4. SI xGMR Field Descriptions
Bit Name Description
0–3 STZx Program L1TXDx to zero for TDM a, b, c or d
0 Normal operation
1 L1TXDx = 0 until serial clocks are available, which is useful for GCI activation. See
Section 15.7.1, “SI GCI Activation/Deactivation Procedure .”
4–7 ENx Enable TDMx. Note that enabling a TDM is the last step in initialization.
0 TDM channel x is disabled. The SI
x RAMs and routing for TDMx are in a state of reset, but all
other SI functions still operate.
1 All TDMx functions are enabled.