Renesas SH7781 - Manual (Page 243)

8. Caches
Rev.1.00 Jan. 10, 2008 Page 213 of 1658
REJ09B0261-0100
31 5 4 2
LW0
32 bits
LW1
32 bits
LW2
32 bits
LW3
32 bits
LW4
32 bits
LW5
32 bits
LW6
32 bits
LW7
32 bits
MMU
[12:5]
255
19 bits 1 bit
Tag V
Address array
(way 0 to way 3)
Data array
(way 0 to way3)
Entry selection
Longword (LW) selection
Virtual address
3
8
22
19
0
Read data
13 12 10 0
6 bits
LRU
Hit signal
(Way 0 to way 3)
Comparison
Figure 8.2 Configuration of Instruction Cache (Cache size = 32 Kbytes)
• Tag
Stores the upper 19 bits of the 29-bit physical address of the data line to be cached. The tag is
not initialized by a power-on or manual reset.
• V bit (validity bit)
Indicates that valid data is stored in the cache line. When this bit is 1, the cache line data is
valid. The V bit is initialized to 0 by a power-on reset, but retains its value in a manual reset.
• U bit (dirty bit)
The U bit is set to 1 if data is written to the cache line while the cache is being used in copy-
back mode. That is, the U bit indicates a mismatch between the data in the cache line and the
data in external memory. The U bit is never set to 1 while the cache is being used in write-
through mode, unless it is modified by accessing the memory-mapped cache (see section 8.6,
Memory-Mapped Cache Configuration). The U bit is initialized to 0 by a power-on reset, but
retains its value in a manual reset.