Renesas SH7781 User Manual
Page 594
13. PCI Controller (PCIC)
Rev.1.00 Jan. 10, 2008 Page 564 of 1658
REJ09B0261-0100
(3)
PCI Command Register (PCICMD)
PCICMD controls the basic functions of the PCIC to generate and respond to PCI cycles. When 0
is written to this register, this register ignores access commands from the external PCI device,
other than configuration access.
0
1
2
3
4
5
6
7
8
9
10
11
12
13
15
14
IOS
MS
BM
SC
MWIE
VGAPS
PER
WCC
SERRE
FBBE
⎯
⎯
⎯
⎯
⎯
⎯
0
0
0
0
0
0
0
1
0
0
0
0
0
0
0
0
R/W
R/W
R/W
R
R
R
R/W
R/W
R/W
R
R
R
R
R
R
R
Bit:
Initial value:
SH R/W:
R/W
R/W
R/W
R
R
R
R/W
R/W
R/W
R
R
R
R
R
R
R
PCI R/W:
Bit Bit
Name
Initial
Value R/W
Description
15 to 10
⎯
All 0
SH: R
PCI: R
Reserved
These bits are always read as 0. The write value
should always be 0.
9 FBBE
0
SH:
R
PCI: R
PCI Fast Back-to-Back Enable
Specifies whether fast back-to-back control is
performed on the different devices or not when the
PCIC is a master.
0: Enables fast back-to-back control for the same target
1: Enables fast back-to-back control for different targets
(not supported)
8 SERRE
0
SH:
R/W
PCI: R/W
SERR Output Control
Controls the
SERR output.
0:
SERR output disabled (pulled up by high impedance
and a pull-up resistor)
1:
SERR output enabled (SERR = low output)
7 WCC
1
SH:
R/W
PCI: R/W
Wait Cycle Control
Controls the address/data stepping.
When WCC is 1, both an address and data, only an
address, and only data are output at master write,
master read, and target read respectively for two clock
cycles.
0: Address/data stepping control disabled
1: Address/data stepping control enabled