H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 137)

116
Item Description
Multicast Suppression
Set multicast suppression. You can suppress multicast traffic by percentage or by
PPS:
• ratio—Sets the maximum percentage of multicast traffic to the total transmission
capability of an Ethernet interface. When this option is selected, you need to
enter a percentage in the box below this option.
• pps—Sets the maximum number of multicast packets that can be forwarded on
an Ethernet interface per second. When this option is selected, you need to enter
a number in the box below this option.
Unicast Suppression
Set unicast suppression. You can suppress unicast traffic by percentage or by PPS:
• ratio—Sets the maximum percentage of unicast traffic to the total transmission
capability of an Ethernet interface. When this option is selected, you need to
enter a percentage in the box below this option.
• pps—Sets the maximum number of unicast packets that can be forwarded on an
Ethernet interface every second. When this option is selected, you need to enter
a number in the box below this option.
Table 45 Link type description
Link type Description
Access An access port can belong to only one VLAN and is typically used to connect a user device.
Hybrid
A hybrid port can be assigned to multiple VLANs to receive and send packets for the VLANs. A
hybrid port allows packets of multiple VLANs to pass through untagged.
Hybrid ports can be used to connect network devices and user devices.
Trunk
A trunk port can be assigned to multiple VLANs to receive and send packets for the VLANS. A
trunk port allows only packets of the default VLAN to pass through untagged.
Trunk ports are typically used to connect network devices.
Modifying a Layer 3 interface
1. Select Device > Interface from the navigation tree.
The page in
Figure 70 appears.
2. Click the icon corresponding to a Layer 3 interface.
The page for modifying a Layer 3 interface appears.